• 検索結果がありません。

東北大学機関リポジトリTOUR

N/A
N/A
Protected

Academic year: 2021

シェア "東北大学機関リポジトリTOUR"

Copied!
4
0
0

読み込み中.... (全文を見る)

全文

(1)

Appendix 1. List of molluscan fossils of the Tatsukobu and Tsubetsu Formations. Tatsukobu Formation: LT-Lower Hard Shale Member,

MT-Sandy Siltstone Member, UT-Upper Hard Shale Member; Tsubetsu Formation: BS-Fine Sandstone Member, LS-Conglomeratic Sandstone Member and Hard Shale Member, S-Siltstone Member r-rare (1-5), F-a few (5-10), c-common (>10); ?-cf.

journal or

publication title

The science reports of the Tohoku University. Second series, Geology

volume 63

number 2

year 1996-07-25

(2)
(3)
(4)

参照

関連したドキュメント

© 2016 KPMG AZSA LLC, a limited liability audit corporation incorporated under the Japanese Certified Public Accountants Law and a member firm of the KPMG network of independent

After the initial pilot period of EuDML, it is envisioned that publishers should contribute to EuDML in this way: selecting a EuDML member that would host a copy of their content,

The Representative to ICMI, as mentioned in (2) above, should be a member of the said Sub-Commission, if created. The Commission shall be charged with the conduct of the activities

Assuming the existence of an upper and a lower solution, we prove the existence of at least one bounded solution of a quasilinear parabolic sys- tems, with nonlinear second

In the papers [81], [84], [85] Kurzweil studied again certain convergence phenomena in ordinary differential equations; these papers amend former results on continuous dependence

Council Directive (( /((( /EEC of (( July (((( on the approximation of the laws, regulations and administrative provisions of the Member States relating

With respect to each good of Chapter 50 through 63 of the Harmonized System, in the case where a material of the other Country or a third State which is a member country of the

The IAEA Operational Safety Review Team (OSART) programme assists Member States to enhance safe operation of nuclear power plants.. Although good design, manufacture and