• 検索結果がありません。

Adaptive Predictive Controller for Hydraulic Systems Driven by Fast Switching On/Off Solenoid Valves

N/A
N/A
Protected

Academic year: 2021

シェア "Adaptive Predictive Controller for Hydraulic Systems Driven by Fast Switching On/Off Solenoid Valves"

Copied!
7
0
0

読み込み中.... (全文を見る)

全文

(1)

Title Adaptive Predictive Controller for Hydraulic Systems Driven byFast Switching On/Off Solenoid Valves( 本文(Fulltext) )

Author(s) JERONYMO, Carlos Eduardo; YAMADA, Hironao; MUTO,Takayoshi

Citation [JSME international journal. Series C, Mechanical systems,machine elements and manufacturing] vol.[39-C] no.[3] p.[522]-[527]

Issue Date 1996-09-15

Rights Japan Society of Mechanical Engineers (日本機械学会)

Version 出版社版 (publisher version) postprint

URL http://hdl.handle.net/20.500.12099/24063

(2)

The Japan Society of Mechanical Engineers

(3)

The Japan Society of Mechanical Engineers

(4)

The Japan Society of Mechanical Engineers

(5)

The Japan Society of Mechanical Engineers

(6)

The Japan Society of Mechanical Engineers

(7)

The Japan Society of Mechanical Engineers

参照

関連したドキュメント

Gate and Drain trace at 90° angle Minimized source inductance to reference point for gate drive minimized. Two independent totem pole drivers very close to

Charge Curve, I INLIM Limits I OCHARGE Assuming that V OREG is programmed to the cell’s fully charged “float” voltage, the current that the battery accepts with the PWM

Output current is sensed via a current−sense resistor RCS, which is connected between the CSP and CSN pins. The sensed signal is internally amplified, and this amplified voltage

The NCP1216 automatically skips switching cycles when the output power demand drops below a given level. This is accomplished by monitoring the FB pin. In normal operation, pin

When the voltage on CV CC reaches the startup threshold, the controller starts switching and providing power to the output circuit and the CV CC.. CV CC discharges as the

Figure 48. At low power levels or in no−load operation, the feedback voltage stays in the vicinity of 400 mV and ensures skip−cycle operation. In this mode, the peak current is

A dedicated comparator monitors the bulk voltage and disables the controller if a line overvoltage fault is detected.. The Fast Overvoltage (Fast−OVP) and Bulk Undervoltage

happens, the latch is not acknowledged since the timer countdown has been prematurely aborted. To avoid this situation, the NCP12510 is equipped with Pre−short logic for OCP