• 検索結果がありません。

CORNBELT TANK AND EQUIPMENT CLEANER

N/A
N/A
Protected

Academic year: 2022

シェア "CORNBELT TANK AND EQUIPMENT CLEANER "

Copied!
2
0
0

読み込み中.... (全文を見る)

全文

(1)

CORNBELT TANK AND EQUIPMENT CLEANER

For Agricultural Tanks and Equipment Commercial and Industrial Use Only

CORNBELT TANK AND EQUIPMENT CLEANER is designed for cleaning tanks, lines and nozzles to remove residues left from pesticides, herbicides and fertilizer.

CORNBELT TANK AND EQUIPMENT CLEANER also removes light rust and dissolves deposit buildups while leaving a protective film that helps prevent corrosion.

CAUTION KEEP OUT OF REACH OF CHILDREN

DO NOT TAKE INTERNALLY

CONTAINS: Complex Phosphates, Sodium Silicate, Sodium Hydroxide, Sodium Carbonate, Monocyclic Terpenes and Nonionic Surfactant.

PRECAUTIONARY STATEMENTS

Irritating to the eyes upon direct contact. Prolonged skin contact may cause irritation. Harmful if swallowed. In case of eye contact, flush with water for 15 minutes. If swallowed, dilute by drinking 2 large glasses of water and consult a physician.

DIRECTIONS FOR USE

For Tanks or Sprayers Equipped with Hand Gun or Hose: Add 1 pound of CORNBELT TANK AND EQUIPMENT CLEANER to 100 gallons of water. Close valve to spray boom, open bypass valve and agitate vigorously for 10 - 15 minutes. Use hand gun or hose to cleanse inside of tank. Open spray boom to flush tank cleaner and water solution out of tank. For sprayers being reused immediately, refill tank with 100 gallons of water, close hand gun valve and empty sprayer through boom nozzles. For sprayers being stored, do not rinse after treatment. CORNBELT TANK AND EQUIPMENT CLEANER leaves a protective film to prevent corrosion.

For Tanks or Sprayers Not Equipped with Hand Gun or Hose: Fill tank with water and add 1 pound of CORNBELT TANK AND EQUIPMENT CLEANER per 100 gallons of water. Then follow above instructions.

IMPORTANT: For best results, fill tank with 1 pound CORNBELT TANK AND EQUIPMENT CLEANER per 400 gallons of water, agitate and circulate throughout entire spray system, let stand 3 to 4 hours. Drain and rinse entire system thoroughly.

For Small Sprayers: Use 1 teaspoon per 1 gallon of water. Agitate vigorously, rinse with water, then repeat procedure once again before reuse.

For Cleaning Fertilizer Equipment: Flush equipment with water. Mix 1 pound of CORNBELT TANK AND EQUIPMENT CLEANER in 50 gallons of water and spray all parts that have been in contact with fertilizer with tank cleaner and water solution.

Always flush with water before reuse.

(2)

2

SPECIAL PRECAUTIONS AFTER USE OF PRODUCTS CONTAINING 2,4-D Corners, cracks, hoses, seals, etc. tend to retain these materials and require special attention. After flushing with CORNBELT TANK AND EQUIPMENT CLEANER, rinse with water as directed, and retain a sample of the rinse water. Apply this sample to a susceptible plant, such as an ornamental, tomato, or vine. Observe after several hours (preferably 24 to 48 hours, depending on weather conditions). If wilting occurs, repeat cleaning process as recommended above.

ALWAYS FOLLOW ALL STATE, FEDERAL AND LOCAL LAWS CONCERNING THE DISPOSAL OF RINSATES.

NOTICE - READ CAREFULLY

Conditions of Sale: Van Diest Supply Co. (and Seller) offer(s) this product for sale subject to and buyer and all users are deemed to have accepted the following conditions of sale and warranty which may only be varied by written agreement of a duly authorized representative of Van Diest Supply Co.

Warranty Limitations: Van Diest Supply Co. warrants that this product conforms to the chemical description of the label and is reasonably fit for the purposes referred to in the use directions on the label subject to the inherent risks referred to below.

Van Diest Supply Co. makes no express warranties. THERE IS NO IMPLIED WARRANTY OF MERCHANTABILITY and there are no warranties which extend beyond the description on the label hereof.

Inherent Risks: The directions for use of this product are believed to be reliable and should be followed carefully. However, it is impossible to eliminate all risks associated with use. Buyer assumes all risks associated with use of this product contrary to label instructions.

Limitation of Liability: In no case shall Van Diest Supply Co. be liable for special, indirect or consequential damages resulting from the use or handling of this product and no claim of any kind shall be greater in amount than the purchase price of the products in respect of which such damages are claimed.

Manufactured for VAN DIEST SUPPLY CO.

Webster City, IA 50595

参照

関連したドキュメント

DIRECTIONS FOR USE: Apply by ground equipment using sufficient water to obtain full coverage of foliage in a minimum of 20 gallons for concentrate spray or a minimum of 100 gallons

Ground Applications: To minimize spray drift, apply FirstStep Herbicide Tank Mix in a total spray volume of 8 gallons or more per acre using spray equipment designed to

Use a 1:10 or 1:20 dilution with water and apply at rates of 27.5-55 gallons or 52.5-100 gallons, respectively, of spray mixture per acre.. California only: Mixers/handlers and

Do not allow aluminium parts to be in contact with concentrated solutions of BRANDT PESTICIDE EQUIPMENT CLEANER for longer than one hour.. Also avoid prolonged contact with

To avoid injury to desirable crops, clean all mixing and spray equipment before and immediately following applications of PERMIT as follows:.. Drain tank; thoroughly rinse spray

0.75 to 0.9 2 to 2.5 Use in sufficient water to assure coverage (1 to 4 gallons of water per acre is normal for this type of equipment), and follow CDA spray instructions for

Apply 0.15 to 0.4 pint of Stinger HL per acre with ground equipment as a broadcast foliar spray or band treatment or with aerial equipment in 5 gallons or more total spray volume

When mixing with Flowables (dry or liquid) and Wettable Powders, add flowables or wettable powders to the half filled spray tank and agitate thoroughly while continuing to fill