Galvanometer Optical Scanner & Driver Special Features Low inertia and high torque Exact linearity and precise position control Superior temperature c

S ADDR Input Selects device address for the two−wire slave serial interface.. When connected to GND, the device ID

18 VDRP Voltage output signal proportional to current used for current limit and output voltage droop 19 VDFB Droop Amplifier Voltage Feedback.. 20 CSSUM Inverted Sum of

• Hybrid Mode Operation: Configuration over Serial Interface and Video over Ethernet.. • AEC−Q101 Qualified and

Config 0x8503 Synchronous Configure the Flash Manager and underlying SPI NVM subsystem Read 0x8504 Asynchronous Read data from the SPI NVM. Write 0x8505 Asynchronous Write data to

Pulling this pin to ground switches the device into Low Power mode and pushing this pin to output voltage switches the device into Active mode.. 2 OUT

The input register translates the SPI input to driver control logic consequently controlling the gate of the LS drivers and the output register transmits the output fault bits and

The second input to the PWM, however, is neither a fixed voltage ramp nor the switch current, but rather the feedback signal from the output of the converter.. This feedback

Table 1 shows an input to output logic table according to the dead time control modes and an enable or the disable operation mode.