General
Power requirements 3.3 V DC (supplied from the IKS-A6011)
Current drain 0.96 A Dimensions (h/d) 116 × 62 mm
(4 5/8 × 2 1/2 inches)
Mass Approx. 0.1 kg (4 oz)
Characteristics
Number of inputs 32 inputs/outputs
Input/output signal uncompressed format 24 bit digital audio signal received and
demodulated on the IKS-A6011/
A6012
Input data transfer rate (sampling rate)
4.928 to 6.144 Mbps (Fs=38.5 to 48 kHz)
Output data transfer rate (sampling rate) 6.144 Mbps (Fs=48 kHz)
• This board is designed to be used with the IKS-A6011 32 D-sub AES/EBU Input Board or IKS-A6012 16 BNC AES/EBU Input Board, and cannot be used alone.
• Single channel double sampling frequency mode of the AES-2003 standards is not supported.
Accessory supplied
Operation and Installation Guide (1)
IKS-RS6010 7 RS-422 Input Board
General
Power requirements 12 V DC Current drain 0.15 A
Dimensions (h/d) 278 × 95.6 mm (11 × 3 7/8 inches)
Mass Approx. 0.3 kg (11 oz)
Characteristics Number of inputs/outputs
7 (D-sub 9-pin) Input/output signal RS-422A signal Input/output data transfer rate
Conforming to the RS-422A standards
Signal transfer distance 1,000 m Accessory supplied
Operation and Installation Guide (1) Note
Notes
IKS-TC6010 16 Time Code Input Board
General
Power requirements 12 V DC Current drain 0.19 A
Dimensions (h/d) 278 × 95.6 mm (11 × 3 7/8 inches)
Mass Approx. 0.4 kg (14 oz)
Characteristics
Number of inputs 16 (BNC type) Input impedance 1kΩ
Input signal Time code (LTC) signal conforming to the electrical and mechanical interface characteristics defined by SMPTE 12M-1999 item 8.6 Standard input signal level
1.0 to 2.0 Vp-p (1kΩ terminated) Maximum input signal level
4.5 Vp-p (1kΩ terminated) Minimum input signal level
0.5 Vp-p (1kΩ terminated) Input data transfer rate
1/4 to 10x normal play speed (NTSC/PAL)
Accessory supplied
Operation and Installation Guide (1)
IKS-V6060M 17 HD/SD Digital Video Output Board
General
Power requirements 12 V DC Current drain 0.35 A
Dimensions (h/d) 278 × 95.6 mm (11 × 3 7/8 inches)
Mass Approx. 0.4 kg (14 oz)
Characteristics
Number of outputs 17 (BNC type) Output amplitude 0.8 Vp-p±10%
Data transfer rate 143 to 1,485 Mbps SDI signal output 143, 177, 270, 360 Mbps:
Conforming to SMPTE259M 540 Mbps: Conforming to
SMPTE344M
1,483.5/1,485 Mbps: Conforming to SMPTE292M
Others: SMPTE259M/
SMPTE292M selectable Signal transfer distance
143 to 540 Mbps: 200 m (when using a BELDEN 8281 cable or equivalent)
1,485 Mbps: 100 m (when using a BELDEN 1694 cable or
equivalent) Accessory supplied
Operation and Installation Guide (1)
IKS-V6060SD 17 SD Digital Video Output Board
General
Power requirements 12 V DC Current drain 0.35 A
Dimensions (h/d) 278 × 95.6 mm (11 × 3 7/8 inches)
Mass Approx. 0.4 kg (14 oz)
Characteristics
Number of outputs 17 (BNC type) Output amplitude 0.8 Vp-p±10%
Data transfer rate 143 to 360 Mbps
SDI signal output 143, 177, 270, 360 Mbps:
Conforming to SMPTE259M Signal transfer distance
200 m (when using a BELDEN 8281 cable or equivalent)
Accessory supplied
Operation and Installation Guide (1)
IKS-A6061 34 D-sub AES/EBU Output Board
General
Power requirements 12 V DC Current drain 0.3 A
Dimensions (h/d) 278 × 95.6 mm (11 × 3 7/8 inches)
Mass Approx. 0.3 kg (11 oz)
Characteristics
Number of outputs 34 (D-sub 37-pin (2), D-sub 25-pin (1), D-sub 9-pin (1))
Output signal 24 bit digital audio signal conforming to AES3-2003 and AES-2id-1996(r2001)6.3, synchronizing with the reference video signal or word sync signal Output signal level 2.7 Vp-p±20% (differential,110Ω
terminated) Output data transfer rate (sampling rate)
6.144 Mbps (Fs=48 kHz) Accessory supplied
Operation and Installation Guide (1)
IKS-A6062 17 BNC AES/EBU Output Board
General
Power requirements 12 V DC Current drain 0.14 A
Dimensions (h/d) 278 × 95.6 mm (11 × 3 7/8 inches)
Mass Approx. 0.3 kg (11 oz)
Characteristics
Number of outputs 17 (BNC type)
Output signal 24 bit digital audio signal conforming to AES3-2003 and AES-3id-1995 4, synchronizing with the reference video signal or word sync signal
Output signal level 1 Vp-p±20% (75Ω terminated) Output data transfer rate (sampling rate)
6.144 Mbps (Fs=48 kHz) Accessory supplied
Operation and Installation Guide (1)
If you use an audio routing switcher, the amount of delay of AES/EBU audio signals varies.
V1.0 and V1.01
When SRC is set to OFF: 104 μs (5 words) When SRC is set to ON: 104 μs (5 words) + 2.1 ms V1.1 or higher
When SRC is set to OFF: 146 μs (7 words) When SRC is set to ON: 146 μs (7 words) + 2.1 ms
SRC: Sampling Rate Converter (IKS-6015)
IKS-A6063 Analog Audio Output Board
General
Power requirements 12 V DC Current drain 1.8 A
Dimensions (h/d) 278 × 95.6 mm (11 × 3 7/8 inches) Mass Approx. 0.4 kg (14 oz) Outputs
Analog audio output D-sub 25-pin (female) (4) 2-channel stereo
Balanced (transformerless electric balance differential output) Output channels 8 stereo
Output impedance less than 50Ω Optimum load more than 600Ω D/A conversion characteristics
Quantization 24-bit linear/48 kHz sampling Headroom 20 dB (at reference level)
Reference output level
+4 dBm (–10 dBm to +8 dBm continuously adjustable) Maximum output level
+24 dBm (600Ω load) Frequency response 20 Hz to 20 kHz
±0.2 dB (AES/EBU input) +0.2/–0.3 dB (analog audio input) (at 1 kHz reference level)
Distortion less than 0.05% (1 kHz, reference level, 30 kHz low pass)
S/N ratio more than 88 dB (AES/EBU input) more than 85 dB (analog audio
input)
(maximum output level, 30 kHz low pass)
Crosstalk less than –85 dB (less than 15 kHz) De-emphasis not applied
Input/output delay
Approx. 1.16 ms (reference value for analog audio input)
Reference input
Audio clock synchronizing with the audio word sync of the IXS-6600/6700 Accessory supplied
Operation and Installation Guide (1)
IKS-RS6060 7 RS-422 Output Board
General
Power requirements 12 V DC Current drain 0.1 A
Dimensions (h/d) 278 × 95.6 mm (11 × 3 7/8 inches)
Mass Approx. 0.3 kg (11 oz)
Characteristics Number of inputs/outputs
7 (D-sub 9-pin) Input/output signal RS-422A signal Input/output data transfer rate
Conforming to the RS-422A standards
Signal transfer distance 1,000 m Accessory supplied
Operation and Installation Guide (1) Reference
IKS-TC6060 17 Time Code Output Board
General
Power requirements 12 V DC Current drain 0.16 A
Dimensions (h/d) 278 × 95.6 mm (11 × 3 7/8 inches)
Mass Approx. 0.4 kg (14 oz)
Characteristics
Number of outputs 17 (BNC type) Output impedance 50Ω or less
Output signal Time code (LTC) signal conforming to the electrical and mechanical interface characteristics defined by SMPTE 12M-1999 item 8.6, excluding item 8.6.3
Output signal level 2 Vp-p±10% (1kΩ terminated) Output data transfer rate
SMPTE mode: 1/4 to 2x normal play speed (NTSC/PAL) (standard setting)
High-speed transfer mode: 1/4 to 10x normal play speed (NTSC/
PAL)
In high-speed transfer mode, electrical characteristics specified by SMPTE 12M-1999 item 8.6 cannot be satisfied, because the waveform of the output signal has a steep slope. It is recommended the use in SMPTE mode to obtain the characteristics that satisfy the above standards.
Accessory supplied
Operation and Installation Guide (1) Note
このマニュアルに記載されている事柄の著作権は当社にあ り、説明内容は機器購入者の使用を目的としています。
従って、当社の許可なしに無断で複写したり、説明内容
（操作、保守等）と異なる目的で本マニュアルを使用する ことを禁止します。
The material contained in this manual consists of information that is the property of Sony Corporation and is intended sole-ly for use by the purchasers of the equipment described in this manual.
Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any purpose oth-er than the opoth-eration or maintenance of the equipment de-scribed in this manual without the express written permission of Sony Corporation.
商標について
•イーサネットは XEROX 社の登録商標です。
•Windowsは米国Microsoft Corporationの米国およびそ の他の国における登録商標または商標です。
About trademarks
• Ethernet is a registered trademark of XEROX Corporation.
• Windows is either a registered trademark or a trademark of Microsoft Corporation in the United States and/or other countries.