• 検索結果がありません。

CROP OIL

N/A
N/A
Protected

Academic year: 2022

シェア " CROP OIL"

Copied!
1
0
0

読み込み中.... (全文を見る)

全文

(1)

8/06

CROP OIL

PRINCIPAL FUNCTIONING AGENTS

Proprietary blend of paraffinic petroleum oil...83.0%

Poly fatty acid esters and polyethoxylated derivatives

thereof...17.0%

Total...100%

All Ingredients are exempt from tolerance levels in CFR 40, 180.1001.

GENERAL INFORMATION

CROP OIL is a combination of surfactants and a proprietary blend of paraffinic petroleum oil designed for use with agricultural chemical spray programs to optimize product performance by increasing penetration into the leaf surface, giving more uniform wetting and more uniform distribution of the active material. Provides improved retention of pesticide deposits under adverse weather conditions.

DIRECTIONS FOR USE

Read directions and conditions of sale. Use in strict accordance with pesticide label cautions, warnings and other directions.

CAUTION: Keep container tightly closed. Do not allow water to be introduced to contents of this container. Do not use CROP OIL in sprays applied during periods of extreme high or low temperature and/or humid conditions. CROP OIL should not be used with any product whose label recommends against the use of a surfactant.

COMPATIBILITY

CROP OIL may be used with wettable powder, emulsifiable concentrate or solution formulations of most of the pesticides, insecticides and miticides now on the market.

Manufacture by:

CUSTOM AGRICULTURAL FORMULATORS P.O. BOX 26104 FRESNO, CA 93729

GENERAL RECOMMENDATIONS FOR USE

Defoliants, Desiccants: Use 1 to 4 pints of CROP OIL per acre in combination with the recommended defoliant or desiccant.

Insecticides & Fungicides: Use 1/2 to 2 pints of CROP OIL per 100 gallons of spray solution in combination with the recommended fungicide.

Herbicides: Use 1 to 4 pints of CROP OIL per acre in combination with the recommended herbicide. NOTE: The above use recommendations are considered to be adequate for most uses. Some pesticides, however, may require higher rates for optimum effect. Follow the pesticide label directions when this occurs. However, do not add this product at a rate that exceeds 5% of the finished spray volume.

PREPARATION OF SPRAY MATERIAL

1. Fill spray or mix tanks with 1/2 to 3/4 the desired amount of water. Start mechanical or hydraulic agitation.

2. Add the required amount of pesticide and the remaining volume of water and mix the contents thoroughly.

3. Add the required amount of this product and continue agitation until a uniform mixture is obtained.

Note: Maintain constant agitation of the spray mixture during standing and application to assure uniform pesticide application.

CA.Reg. No. 1051080-50036-AA

IMPORTANT : READ PESTICIDE LABEL BEFORE USING THIS PRODUCT.

CAUTION: KEEP OUT OF REACH OF CHILDREN:

Hazardous to humans and domestic animals. Harmful if swallowed.

Avoid contact with eyes, skin or clothing. In case of contact, immediately flush eyes or skin with plenty of water. Get medical attention if irritation persists.

FIRST AID: If this product gets into the eyes, immediately wash the eyes with large amounts of water for at least fifteen minutes. Seek immediate medical treatment. If this product gets on the skin, immediately wash the contaminated area. Seek medical attention if skin irritation persists. If this product has been swallowed and the person is conscious, immediately give large volumes of water. Do not induce vomiting. Seek immediate medical treatment

CONDITIONS OF SALE

Follow directions carefully. Timing and methods of application, weather and crop conditions, mixtures with other chemicals not specifically recommended, and other influencing factors in the use of this product are beyond the control of the seller. Buyer assumes all risks of use, storage or handling of this material not in strict accordance with direction given herewith.

STORAGE AND DISPOSAL

Do not contaminate water, food or feed by storage or disposal. Follow all recommended governmental

procedures for disposal of pesticide spray solutions. Triple rinse container, empty rinsate and spray tank. Dispose of empty containeraccording to local practices: Contact county agricultural commissioner for container disposal information.

参照

関連したドキュメント

Succeed ® /Ultra is designed for use at a lower use rate than traditional methylated seed oil-based adjuvants with a broad range of herbicides, fungicides, and insec- ticides

Check the pesticide label for specific crop use, timing and methylated seed oil or oil concentrate rate required for that pesticide.. RATES

Dilute: Apply 500 – 2000 gallons of spray solution per acre using 1.2 – 1.4 gallons of oil per 100 gallons of water (in TX and FL maximum 1500 gallons of spray mix per

Under dry conditions or during cool weather, a petroleum based crop oil concentrate, or vegetable-seed oil-based product may be used in place of a nonionic surfactant at 1-2

For optimum disease control, tank mix Custodia with the lowest specified rate of a spray adjuvant such as a non-ionic surfactant, crop oil concentrate, or blend at the

warrants that this product conforms to the chemical description on the label subject to the inherent risks referred to below. makes no

Respiratory protection is not normally required but if vapors exceed acceptable level, wear a MSHS/NIOSH approved respirator to protect against vapors.. Follow

PPE required for early entry to treated areas that is permitted under the Worker Protection Standard and that Involves contact with anything that has been treated, such as plants,