Dry Man 20
0-0-7
A WATER SOLUBLE PLANT FOOD CONCENTRATE
GUARANTEED ANALYSIS
Soluble Potash (K2O) ………...……….... 7.00%
Manganese (Mn)... 20.00%
20.00% Water Soluble Manganese (Mn)
Derived from: Potassium Citrate, Manganese Sulfate and Citric Acid.
KEEP OUT OF REACH OF CHILDREN
WARNING
Causes eye irritation. Harmful if inhaled. May cause damage to central nervous system and lungs through prolonged or repeated inhalation.
PRECAUTIONARY STATEMENTS
Wash hands thoroughly after handling. Do not breathe dust. Use only outdoors or in a well-ventilated area. Dispose of contents/container in
accordance with Federal, state and local regulations.
FIRST AID
IF IN EYES: Rinse cautiously with water for 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical attention.
IF INHALED: Remove person to fresh air and keep comfortable for breathing. Call a poison control center or doctor for treatment advice if you feel unwell.
Get medical attention if you feel unwell.
In case of medical emergency, call toll free 1-877-424-7452.
FOR EMERGENCY, SPILL, LEAK, FIRE, EXPOSURE, OR ACCIDENT, CALL: CHEMTREC 1-800-424-9300
COMPATIBILITY: DRY MAN 20 is compatible with most commonly used pesticides. Do not use with lead arsenate, hydrated lime, lime sulfur, or other strongly alkaline materials. Do not use with amine form of 2,4-D or with dicamba (e.g. Banvel®). In all cases, it is recommended that a jar test be made to determine compatibility of DRY MAN 20 with other materials before proceeding with high volume mixing.
NOTE: This product is not recommended for use with copper or tin fungicides. These mixtures can be phytotoxic and damage the crop.
WARRANTY DISCLAIMER
Winfield Solutions, LLC warrants only that the chemical composition of this product conforms to the ingredient statement given on the label, and that the product is reasonably suited for the labeled use when applied according to the Directions for Use. SELLER MAKES NO OTHER EXPRESS OR IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, NOR IS ANY REPRESENTATIVE OF SELLER AUTHORIZED TO MAKE ANY SUCH WARRANTY OR MODIFY THESE TERMS. This warranty does not extend to the storage, handling or use of this product contrary to label instructions, or under abnormal conditions, or under conditions not reasonably foreseeable to Seller, and Buyer assumes the risk of any such storage, handling or use. Seller shall not be responsible for incidental or consequential damages, if any, resulting from a breach of warranty.
GENERAL DIRECTIONS
DRY MAN 20 is generally compatible with pesticides and other fertilizers.
Determine compatibility with a jar test before mixing products.
Mixing Instructions
• Fill tank with water. Start agitation. Add DRY MAN 20 slowly and continue agitating until product is completely dissolved. Use this procedure only. DO NOT pre-mix as slurry. Add pesticide last.
• When temperatures are cold, allow extra time for this product to completely dissolve.
POTATOES: Foliar - Use 1 to 1.5 lbs of product. per acre. Apply when plants are 4” to 6” high (hooking stage). Subsequent applications at 2 to 3 week intervals.
CORN: (Field and sweet). Foliar - Use 1 to 2 lbs. per acre. Apply when corn is 6”-8” high and again prior to tasseling. DRY MAN 20 can be mixed with glyphosate herbicides, please follow special mixing instructions below
SOYBEANS: Foliar – Apply 1 to 2 lbs per acre when the beans are in the 2nd to 4th trifoliate and again during bloom and earlier pod fill. DRY MAN 20 can be mixed with glyphosate herbicides, please follow special mixing instructions below.
Mixing Instructions for tank mixing with glyphosate Herbicides
1. Fill tank ½ full and add water condition agents. Class Act® NG® is the preferred condition agent when using DRY MAN 20.
2. Add DRY MAN 20. Make sure it is fully dissolved before progressing to step 3. The temperature of the spray water will affect the amount of time it takes for the DRY MAN 20 to completely dissolve.
3. Add your glyphosate herbicide 4. Add any other pesticide and ill tank.
Information regarding the contents and metals contained in this product can be obtained by writing to: Winfield Solutions, LLC, P.O. Box 64589, St. Paul, MN 55164, referring to the item number found on this bag.
Class Act® and NG® are registered trademarks of Winfield Solutions, LLC.
Banvel® is a registered trademark of BASF Corporation.
NET WEIGHT: 25 Lbs (11.34 kg)
Manufactured By:
Winfield Solutions, LLC
PO Box 64589, St Paul, MN 55164-0589
1/0829/9
