• 検索結果がありません。

木曽町結婚祝金支給要綱

N/A
N/A
Protected

Academic year: 2018

シェア "木曽町結婚祝金支給要綱"

Copied!
6
0
0

読み込み中.... (全文を見る)

全文

(1)

○木曽町結婚祝金支給要綱

平成27年3月13日 告示第34号 改正 平成28年3月24日告示第31号 (趣旨)

第1条 この告示は、木曽町(以下「町」という。)に定住している者が結婚し、地域の過疎化及び

少子化を緩和するため、木曽町結婚祝金(以下「祝金」という。)を支給することについて必要な

事項を定めるものとする。

(支給対象者)

第2条 祝金の支給対象者は、次に掲げる要件を満たす者とする。

(1) 町に婚姻届を提出した者

(2) 夫婦となる双方又は配偶者となる者が現に他の市町村に住所を有し、結婚後に転入によ

り夫婦双方が町に居住し、5年以上定住の意思のある者

(3) 過去に祝金の支給を受けていない者

2 前項の規定にかかわらず、町長が認めたときは、祝金を支給し、又は支給しないことができる。 (祝金の額)

第3条 祝金の額は、1組あたり10万円とする。 (支給申請等)

第4条 祝金の支給を受けようとするときは、木曽町結婚祝金支給申請書(様式第1号)を町長

に提出するものとする。

2 町長は、前項の規定により申請書の提出を受けた場合において、内容を審査し、支給を決定し

たときは、木曽町結婚祝金支給決定通知書(様式第2号)により支給対象者に通知するものとす

る。

(支給時期及び支給方法)

第5条 祝金は、支給決定の通知後6カ月を経過した後、支給対象者が指定した金融機関の口

座に振り込むものとする。

(支給要件を満たせなくなった場合の措置)

第6条 支給対象者は、祝金の支給が決定された後、第2条第1項第2号に規定する定住の要

件を満たせなくなった場合は、その理由を記載した書面を町長に提出するものとする。 2 前項の場合において、祝金が未支給であるときは、祝金は支給しない。

附 則

(2)

この告示は、公布の日から施行する。

附 則(平成28年3月24日告示第31号) この告示は、平成28年4月1日から施行する。

(3)
(4)
(5)
(6)

様式第1号(第4条関係) 様式第2号(第4条関係)

参照

関連したドキュメント

We have seen that under rather natural source condi- tions error estimates in Bregman distances can be extended from the well-known quadratic fitting (Gaussian noise) case to

In Proceedings Fourth International Conference on Inverse Problems in Engineering (Rio de Janeiro, 2002), H. Orlande, Ed., vol. An explicit finite difference method and a new

Yang, Complete blow-up for degenerate semilinear parabolic equations, Journal of Computational and Applied Mathematics 113 (2000), no.. Xie, Blow-up for degenerate parabolic

It is well known that the inverse problems for the parabolic equations are ill- posed apart from this the inverse problems considered here are not easy to handle due to the

If the Picard iteration can be shown to converge, establishing existence and uniqueness of a solution to the IVP, then a polynomial vector field will preserve the polynomial form of

Gate and Drain trace at 90° angle Minimized source inductance to reference point for gate drive minimized. Two independent totem pole drivers very close to

An 30 m A internal current source flows through R_ILIM, creating a reference voltage, and the voltage drops on R DSON of both high- and low-side MOSFETs are used to compare with

Upon being enabled or released from a fault condition, and after the Enable Delay Time, a soft−start circuit ramps the switching regulator error amplifier reference voltage to